Harken 7411.11 1/2 MKIV Jib Reefing & Furling - Manual (Page 32)

Tip: Do not remove foil clamp screws to adjust foil.
Loosen screws, hold foils and bring clamp away
from foils. Adjust and reclamp.
Assembly Feeder/Final
Slide halyard swivel above feeder. Place feeder in foil
recess. Push screw down so tab catches under foil.
Tighten screw.
Note: Screw will turn with some difficulty. It is plastic
coated to prevent loosening due to vibration.
Important! When removing feeder, loosen screw no more
than one full turn. Slide screw up and remove feeder.
32 MKIV Underdeck Unit 1, 2, 3