Harken 7411.11 1/2 MKIV Jib Reefing & Furling - Manual (Page 19)

Preassembly Confirm Foil Length
Line up bottom foil so foil clamp is just
above or below center of notches in
bottom foil.
Confirm foil length by laying foils along-
side stay with turnbuckle components
and torque tube assembly. Pull stay out
straight. Line up turnbuckle eye with a
point just above bottom of torque tube
assembly. This point will line up with
Jaw/Jaw toggle pin. See chart above right.
Note: Position top foil so that with top
cap the foil will ride 5/8" (16 mm) below
terminal. If wire fitting at top of stay is
swage, foil must ride just below shoulder
of swage. Mark cut line on foil. Wrap tape
around foil as a guide so cut is straight.
Unit Pin
Jaw/Jaw Toggle Pin to Bottom of
Torque Tube Assembly
1 1 / 2 " (12.7 mm) 7 / 16 " (11 mm)
2 5 / 8 "(15,9 mm) 1 / 4 " (6 mm)
3 3 / 4 " (19.1 mm) 5 / 8 "(16 mm)
3 7 / 8 "(22.2 mm) 1" (25 mm)
MKIV Underdeck Unit 1, 2, 3 19