Guralp Systems CMG-DM24 User Manual
Page 84
CMG-DM24
ALL-DATA
Syntax: ALL-DATA
Instructs the DM24 to transmit all the data streams it holds next time a
DOWNLOAD is issued. This command does not alter the read point or
time period; you should either specify a time period or use the ALL-
FLASH command in addition to this one.
STREAM
Syntax: STREAM stream-id (n.b. - trailing parameter)
Instructs the DM24 to transmit only the stream with ID stream-id.
Stream IDs are normally a 4-character device code (e.g. HPA0) followed
by a component letter (N) and a tap number (1).
* Unlike most FORTH commands, the stream-id parameter goes
after the command.
STATUS-ONLY
Syntax: STATUS-ONLY
Instructs the DM24 to transmit only status streams (text streams,
normally with stream IDs ending in 00).
S/S
Syntax: rate S/S
Instructs the DM24 to transmit only streams with sample rates equal to
rate. If rate is zero, only status streams are transmitted.
Note that this command should not be confused with the
SAMPLES/SEC command.
ALL-TIMES
Syntax: ALL-TIMES
Clears any time selection in force, allowing you to download all data
held by the DM24. This command does not alter which streams are to
be transmitted; you should specify streams or use the ALL-DATA
command in addition to this one.
84
Issue N