Guralp Systems CMG-DM24 - Manual (Page 79)

Operator's guide
•
COMPLETE, to display all events currently held in Flash
memory.
•
yyyy mm dd hh mm SEARCH, to look for events in the 10-
minute period defined by yyyy mm dd hh mm, For example,
2005 12 26 04 13 SEARCH EVENTSLIST
will display events between 04:10 and 04:20 on the 26 th of
December, 2005. The time format is the same as for FROM-TIME
and TO-TIME, as documented in section 5.10, page 85.
* If an event has occurred, but nothing was filed (for example,
because the digitizer is in DIRECT mode), it will be listed with
the message No File.
•
two numbers event-id number-of-events, to display
number-of-events starting at event number event-id.
RESET-LIST
Syntax: RESET-LIST
Empties the events list. You will no longer be able to see event
information with the EVENTSLIST command, or download events
with EVENTS (see below).
This command does not delete any data. If you empty the events list,
and the digitizer is in a suitable transmission mode, you can still
download event data using the commands in Section 5.10,
'Downloading over the serial port', on page 83.
DIRECT
Syntax: DIRECT
Instructs the DM24 not to use Flash memory for storage. Instead, all
data is transmitted directly to clients. A temporary RAM buffer allows
clients to request blocks they fail to receive using the Block Recovery
Protocol.
FILING
Syntax: FILING
Instructs the DM24 not to transmit blocks to clients, but to store all
digitized data in the Flash memory. The memory is used in circular
October 2009 79