Guralp Systems CMG-DM24 - Manual (Page 113)

Operator's guide
8 Connector pinouts
8.1 SENSOR A and B ports
These are standard 26-pin “mil-spec” plugs,
conforming to MIL-DTL-26482 (formerly
MIL-C-26482). A typical part-number is
02E-16-26P although the initial “02E” varies
with manufacturer.
Suitable mating connectors have part-
numbers like ***-16-26S and are available
from Amphenol, ITT Cannon and other
manufacturers.
Pin Function Pin Function
A Vertical velocity +ve P Calibration signal
B Vertical velocity –ve R Vertical calibration enable
C N/S velocity +ve S N/S calibration enable
D N/S velocity –ve T E/W calibration enable
E E/W velocity +ve U Centre
F E/W velocity –ve V not connected
G Vertical mass position W Unlock
H not connected X Lock
J N/S mass position Y Logic signal ground
K Busy indicator LED Z not connected
L E/W mass position a not connected
M not connected b Power 0 V
N Signal ground c Power +10 to +24 V
Wiring details for the compatible socket,
***-16-26S, as seen from the cable end.
October 2009 113