Guralp Systems CMG-DM24 - Manual (Page 58)

CMG-DM24
1 4800 BAUD
2 38400 BAUD
This will reset a standard single-sensor DM24 to its default
configuration.
The allowable values for baud-rate are 4800, 7200, 9600, 14400,
19200, 38400, 57600, 115200 and 230400. For compatibility reasons,
1152 is also accepted, setting the baud rate to 115200.
* The GPS port (port 1) should always be set to 4800 baud.
STOPBITS
Syntax: port number-bits STOPBITS
Sets the number of stop bits used for one of the serial ports on the
DM24. port can be:
•
0, for the DATA OUT port;
•
1, for the GPS port; or
•
2, for the DATA IN port.
By default, the DM24 uses 1 stop bit on all ports.
+MODEM
Syntax: +MODEM (interactive)
Instructs the DM24 to use a modem connected to the DATA OUT port
to contact a remote device and transmit data stored in the Flash
memory.
The DM24 can dial out every time it generates a heartbeat message,
and also whenever a trigger occurs. You can change the interval
between heartbeat messages with the HEARTBEAT command, below.
When you issue +MODEM for the first time, the digitizer will prompt
you to enter a telephone number:
+MODEM
Phone# is not set Enter phone# 00441189819056
Phone# 00441189819056 Flash FIFO : Circular Configuration for
dial out ok_DEMO00
58 Issue N