Guralp Systems CMG-DM24 User Manual
Page 78
CMG-DM24
RESET-FLASH
Syntax: RESET-FLASH
Resets the Flash memory pointers. The DM24 will start overwriting old
data from the beginning of memory. You can still access this data,
however, up until the point it gets overwritten (unlike ERASEFILE).
ERASEFILE
Syntax: ERASEFILE (interactive)
Removes all data from the Flash memory and resets all pointers to the
beginning. You will be asked for confirmation before you do this, as all
data will be destroyed.
If you have been running the DM24 with a FireWire disk attached,
remember that there will be some data still in Flash memory awaiting
transfer (up to the amount you last set with MBTRANSFER). You
should make sure this data is transferred with the DISKMENU
command before you issue the ERASEFILE command.
Depending on the amount of Flash memory installed, ERASEFILE may
take several minutes to complete.
EVENTSLIST
Syntax: event-specification EVENTSLIST
Displays details of triggered events. The parameter event-
specification can have several forms:
•
RECENT, to display the most recent events. By default, 16 events
are displayed. You can double or halve this number by prefixing
RECENT with either SHORTER or LONGER. You can use several
of these commands together. For example, the command
LONGER LONGER RECENT EVENTSLIST
will display 64 events. The DM24 remembers this setting, so a
further LONGER RECENT EVENTSLIST would display 128
events.
•
EARLIER, to display the previous set of events of the currently-
configured length, e.g. if RECENT EVENTSLIST displays the 16
events #30 to #45, EARLIER EVENTSLIST will display the 16
events #14 to #29.
78
Issue N