Assembling the gf- primo jib – Grip Factory Munich GF-Primo User Manual
Page 43
GF-Primo / GF-Secondo Dolly System Instruction Manual
Page: 42
ASSEMBLING THE GF-Primo Jib:
Insert the locking
pin to connect the
middle section to
the rod.
Fit the connection
rod onto the steel
pin
and
hand
tighten the locking
bolt.
Secure
by
pulling
locking lever
Secure
the
locking bolt by
turning it into
the Euro-adapter
Place the middle section of the GF-Primo
Jib on to the column’s Euro-adapter.
Note: the front of the jib should be
mounted on the same side as the
electronic housing.
Jib
front
and
electronic
housing
Connect the rear
section
to
the
middle section by
joining the key link
pin to the slot and
dropping down.
Hand tighten the
locking bolt and
secure
by
tightening
the
locking lever.