Getting started, Electronic unit components – Grip Factory Munich GF-Primo User Manual
Page 22
GF-Primo / GF-Secondo Dolly System Instruction Manual
Page: 21
Electronic Unit Components
The following describes the electronic components
:
Getting started
In general, when the dolly arrives from the factory it will be set up to be switched on in either
Wireless Mode or with Cable connection.
To switch on the dolly requires the following:
In Wireless mode:
Dolly batteries must be charged and connected correctly (see page 7)
Electronic and HCU must be on the same channel (see page 23)
HCU battery is charged and inserted into the HCU
The Emergency Switch must be off i.e. switch extended (see page 23)
In Cable mode:
Dolly batteries must be charged and connected correctly
(see page 7)
Electronic and HCU must be connected via cable (see page 25)
The Emergency Switch must be off i.e. switch extended (see page 23)
Starting off
In wireless mode: Check that Electronic and HCU are on the same channel.
Cover for Back Up Drive System
Channel Selector
Emergency Off Switch!
Press to deactivate
electronic!
Must be extended to
allow operation!!
Connectors for Hand Control Cable
On- / Off-Switch with Status-LED
Turn dial to select
channel