Grip Factory Munich GF-Primo - Manual (Page 23)

GF-Primo / GF-Secondo Dolly System Instruction Manual
Page: 22
Switch on by first pressing the On/Off Switch on main electronic housing. Wait a few seconds until the
LED on the switch starts blinking red/green, then press the On/Off button on the HCU. The display will turn
red, then blue. The column is on.
In cable mode: Switch on by pressing the On/Off button on the HCU. The display will turn red, then blue. The
column is on.
Note: Check to make sure the Emergency OFF Switch is not active. It should be extended, not
pushed in.
LED off
LED red
LED green / red
blinking (ready)
Display off
Display red
Display blue (ready)