Grip Factory Munich GF-Primo - Manual (Page 18)

GF-Primo / GF-Secondo Dolly System Instruction Manual
Page: 17
Disconnecting the GF-Secondo Combi-wheel from the steering and
removing the Combi-wheel unit
Going on Track:
When driving onto track using a drive
ramp, ensure that the track wheel brakes
on the Combi-wheels are at the rear of
the wheel as it goes onto the track. If not
the brake will engage and stop the dolly
from moving.
Track wheel
brakes at the rear
of the wheel
Locking pin to
remove Combi-
wheel
Selector switch
pointing downwards:
Disconnected from
steering = wheel
rotates freely i.e. on
Position SP3
To remove the GF-Secondo Combi-wheels from the Base-Dolly set the selector switch at position SP3. Then pull
the Locking Pin to remove the wheel unit by moving it downwards. Remove carefully and with caution! Hold the
wheel securely so it doesn’t drop off!!
Attention: Before removing the Combi-wheels either support the base from underneath allowing sufficient
clearance to remove the wheel. Alternatively, turn the base upside down and lift the wheel off. Remove carefully
and with caution!