Grip Factory Munich GF-Primo - Manual (Page 37)

GF-Primo / GF-Secondo Dolly System Instruction Manual
Page: 36
Synchronizing the Hand Control Unit and Column
In general, when delivered, the electronic and HCU will already be synchronized and both units will be
selected to the same channel to ensure that wireless mode can be used.
If however, the HCU or electronic unit are replaced, the new unit must be synchronized with the original
opposite unit i.e. if the HCU is replaced it must be synchronized with the original electronic.
Attention:
In wireless mode, only 1 HCU unit can be synchronized with the electronic at any one time.
To use a different HCU requires it to be firstly synchronized! To revert back to the first HCU
requires it to be re-synchronized.
Connect the HCU to the electronic with the cable and switch on the column using the On/Off switch (red
button) on HCU.
Tip:
When connecting the Fischer Plug align the red dots
Cable connection
Cable connection from HCU
to Column
Note the
alignment marking
on Fischer Plugs
Red dots
Display off.
Press „On“
button
After pressing the
„On“ button the
display turns red
Display blue (ready)