Grip Factory Munich GF-Primo - Manual (Page 34)

GF-Primo / GF-Secondo Dolly System Instruction Manual
Page: 33
Settings such as Speed and Ramp are accessible and even different Speeds and
Ramps can be selected between the various positions.
Tip: In between the various MARKERS it is possible to make manual
moves and to control the speed by pressing the Rocker Switch, more
or less to go faster or slower.
By using the Rocker Switch drive to the first MARKER, with the lowest, flashing
digit, e.g. MARKER 1.
Note: After changing to Mode M, the lowest numerical digit will be suggested
as the first MARKER and will blink. As soon as the first position is
reached, the second or next MARKER will be indicated through
flashing and the lift range between these 2 positions will be set.
Attention:
By pressing the MARK Button you can select other MARKERs as the
next position.
Press the MARK Button and use the Rocker Switch to move to the flashing digit /
MARKER.
Tip:
The present height is shown on the display with the numerical display
and on the other hand with the shaded vertical bar display. The
direction of the next position is visible.
The column can now be driven in the selected Speed and Ramp and upon reaching
the MARKER it will stop automatically. The next MARKER can recognised as the
respective digit will blink and the vertical height bar will show the new lift range.
Tip:
As long as the next MARKER is not reached, movement between the
2 respective MARKERS is not restricted so direction or speed changes
are possible.
Selecting MARKERs