Gasboy FuelOmat Payment Terminal - Manual (Page 66)

OrPT Manual 56
O R P A K S Y S T E M S L T D
S Y S T E M T A R T I N G U P 4 8 5
V E R 5 . 2 1 ( 4 6 )
E T H : 1 9 2 . 1 6 8 . 1 . 2 1 1
Figure 5-2. OrPT Start-Up Screen
After several seconds, the “SYSTEM” screen is displayed. This screen shows at first the
“STARTING UP” message, see Figure 5-2. A second later, the 485 indication - the OrPT is
connected to an RS-485 link - is shown. You are now enabled to perform a new definition of the
RS-485 address. This screen lasts 30 seconds. To define the RS-485 address:
1. Press the OK key in the OrPT keyboard. The Password screen is displayed.
2. Proceed as described below.
5-3.3. OrPT Address Definition
The OrPT address definition requires authorizing the procedure by entering the password, as shown
in Figure 5-3. The password can include up to six digits.
N N O O T T E E
You do not have to explicitly specify the RS-485
address on each startup. If a new password is not
entered after several seconds, the OrPT uses the
previous address, stored in its memory, and proceeds
with the startup process.
To insert your password:
1. Press the keyboard numeral keys to enter your password
W R I T E P A S S W O R D
_ _ _ _ _ _
S N : 1 9 0 0 7 0 7 2 6 4 6 0 0 5
Figure 5-3. Password Screen
2. Press OK key. The Write Address screen is displayed, see Figure 5-4.
To enter an RS-485 address for the OrPT: