Daktronics Venus 1500 Ver 2.x - Manual (Page 57)

· InfoNet Displays (excluding model G-1000 Displays): Revision 14 or higher
(Firmware Number ED-10133)
· Venus 1500 Controlled DataTrac Displays: Revision 16 or higher (Firmware
Number ED-10132)
· Galaxy, SunSpot or Glow Cube displays: Revision 17 or higher (Firmware Number
ED-10134 for Galaxy Displays; ED-12699 for RGB Galaxy Displays)
Select the desired test from the drop down menu. “Cycle All” will run all of the listed tests. Click
on [
START TEST ]. Once testing is complete, click on [ STOP TEST ].
L
Note: Not all listed tests will work with every display. If a particular test does not appear on
your display, then that test is not supported in the display’s firmware.
Temperature Offset
The temperature offset is used when the external temperature sensor at the display site needs to be
adjusted to reflect the true outside temperature. The offset increases or decreases the measured
temperature by the specified amount before showing it on the display.
Use the up and down arrows to specify the amount of offset. The temperature can be adjusted by
plus or minus 9 degrees Fahrenheit. Click on [
SET TEMPERATURE OFFSET ] to activate the
adjustment.
Reset Display
[ RESET DISPLAY ] restarts the controller inside the selected display. Refer to the display’s
maintenance and troubleshooting manual for the list of boot up initialization information that will
appear on the display upon reset.
To remove all messages and schedules saved at the display site, check the box next to Clear
Display Memory, and then click on [
RESET DISPLAY ]. A confirmation dialog box appears. Select
[ YES ] to continue the reset command.
The Available Memory for the display should be “empty” the next time you retrieve the display’s
status. The display time and date will default to midnight on 01/01/95.
C AUTION : Resetting the display will temporarily interrupt operation and is typically used only
during troubleshooting.
7.4 About the Display Manager
Click on the Venus 1500 drop-down menu and select About.
The dialog box lists Daktronics contact information and customer service phone numbers.
Click on [
OK ] to close the box and return to the Display Manager.
The Venus 1500 Display Manager 7-7