Daktronics Venus 1500 Ver 2.x - Manual (Page 13)

Section 2: Installation
The Venus 1500 software must be installed to a hard disk before use. To install the software onto a
computer, follow these steps:
1. Place the Venus 1500 installation compact disk (CD) into the appropriate CD ROM (presume
drive D:).
2. The installation should begin automatically within a few seconds. If it does not, click on the
Start button and select Run from the menu. Type “D:\SETUP” and press < ENTER >.
3. Follow the instructions on the screen. SETUP will copy the files necessary to run the Venus
1500 software to the hard disk and create Venus 1500 in the Start menu. Note: The Venus
1500 software installs to the C:\Program Files\Daktronics\Venus 1500 directory by default;
this is the recommended location.
4. The Venus 1500 control software is now installed and ready to be configured for use with the
Venus 1500 Display Network.
Installation 2-1