Cybex 525AT Arc Trainer - Manual (Page 61)

61
Cybex Service Manual
Remove components from bezel assembly
1. Unplug handset cable and thumb control cables from bezel.
3
7
6
1
2
3
3
4
4
5
1
Description
1 Thumb control cable (2)
2 Handset cable
3 Screw (4)
4 Cable clamp (2)
5 E-Stop panel
6 Heart rate sensor
7 Heart rate cable
2. Remove the two screws securing the cable clamps to the bezel using a Phillips screwdriver.
3. Remove the two screws securing the E-Stop panel to the bezel using a Phillips screwdriver.
4. Remove the heart rate sensor from the bezel using a utility knife. Do not damage heart rate
sensor. Note position and orientation of heart rate sensor.
5. Remove the two screws securing the book tabs to the bezel using a Phillips screwdriver.
1
4
2
3
4
7
8
5
6
Description
1 Bezel
2 Book tab (2)
3 IR sensor
4 Screws (6)
5 Ferrite (optional)
6 MCC board
7 iPod board (optional)
8 Monitor
6. Remove the IR sensor, optional ferrite and optional iPod board using a utility knife. Do not
damage IR sensor. Note position and orientation of IR sensor.
7. Remove the four screws securing the MCC board to the monitor using a Phillips screwdriver.