Cybex 525AT Arc Trainer - Manual (Page 34)

34 35
Cybex Service Manual
Crank Covers
Remove crank covers
1. Remove both screws securing crank cover using a Phillips screwdriver.
1
4
5
3
2
Description
1 Crank cover
2 Screws (2)
3 Crank arm
4 Crank Shaft
5 Flush mount
2. Remove crank cover.
Inspect crank arm mounting. Crank arm should be flush with crank shaft. Adjust with 7/16” or 1/2”
socket wrench if needed.
Shrouds
Remove both shrouds
1. Remove screws securing each shroud in place using a long Phillips screwdriver.
2. Remove both shrouds.
Release drive belt tension
Using a 7/16” or 1/2” socket wrench, loosen the two Hex Head Cap Screws (HHCS). Alternate a few
turns to each HHCS until they bottom out (DO NOT REMOVE).
3
2
1 Description
1 HHCS
2 Lower pivot shaft
3 Drive belts