Cybex 525AT Arc Trainer - Manual (Page 31)

31
Cybex Service Manual
Remove linkage arm
Remove SHCS, flat washer, cap, and spacer securing linkage arm to arm handle using a 3/16” Allen
wrench.
3
5
4
6
2
1
Description
1 Arm handle
2 Linkage arm
3 Spacer
4 Flat washer
5 SHCS
6 Cap
Remove arm handle
1. Remove BHSCS, washer, and pivot pin securing arm handle using two 7/32” Allen wrenches.
The BHSCS and washer from only one side needs to be removed.
2
5
4
1
6
3
4
Description
1 Arm handle
2 Pivot pin
3 BHSCS
4 Washer
5 BHSCS
6 Loctite
2. Remove arm handle.
Install new arm handle
1. Place new arm handle in position and slide pivot pin back in place.
2. Apply loctite to threads of BHSCS and inside the pivot pin (where BHSCS will be tightened
into).
3. Install BHSCS and washer to pivot pin. Tighten BHSCS using two 7/32” Allen wrenches
securely. When tightened properly, frame tabs are pulled tight to the bearing.