Cybex 525AT Arc Trainer - Manual (Page 40)

40 41
Cybex Service Manual
Install both shrouds
1. Place both shrouds in position.
2. Tighten the screws securing each side cover using a long Phillips screwdriver.
Install crank covers
1. Place each crank cover in position.
4
1
5
3
2
Description
1 Crank cover
2 Screws (2)
3 Crank arm
4 Crank shaft
5 Flush mount
2. Place loctite on the screws securing crank covers.
3. Install the screws securing each crank cover in place using a Phillips screwdriver.
Install linkage rods
1. Place linkage rod in correct position.
5
1
2
4
3
Description
1 Flat washer
2 Cap
3 Linkage rod
4 Spacer
5 SHCS
2. Place a drop of loctite on the SHCS and place another drop of loctite into the shaft (where the
SHCS will be tightened into).
3. Install spacers, caps, flat washers, SHCS. SHCS must be tightened to a minimum of 90 lbs-in.
Test unit for proper operation
1. Plug the power cord into the power outlet.
2. Operate the unit at all levels to verify proper operation.