Cybex 525AT Arc Trainer - Manual (Page 60)

60 61
Cybex Service Manual
MCC board cables
1 2 3
5 6 4 7 8 9
Description
1 CSAFE (optional)
2 Display
3 E3 View monitor
4 A/V
5 Headphone jack
6 iPod (optional)
7 Heart rate
8 Handset membrane
9 iPod board assembly (optional)
1. Unplug optional iPod cable. The iPod cable is held in place by a notch in the access cover.
A. Press in both side latches of the cable connector.
A
B
C
DO NOT PULL
CONNECTOR OUT
BY THE WIRES!
B. Ensure the latches disengage from the connector.
C. Unplug cable by holding down the latches on both sides and pulling straight out from the
connector. Do not pull on wires, remove by connector.
2. Unscrew the coax cable from the E3 View Monitor.
3. Remove the ground cable from the E3 View Monitor using a 11/32” nut driver.
4. Unplug optional CSAFE cable from the MCC board.