Cybex 525AT Arc Trainer - Manual (Page 47)

47
Cybex Service Manual
Connect power cord
Plug the power cord into the power outlet.
Perform calibration procedure
1. Hold the handrails to steady self while stepping into the foot plates.
2. Begin striding.
3. Press and the hold the Display option
MEMBRANE, HANDSET,
ARC, BIKE, TREADMILL,
ENGLISH
B A
REVISIONS
DESCRIPTION
See sheet 1
ECO REV D A TE APPRO V AL BY
10 TROTTER DRIVE
MED W A Y , MA
RE V .
SHEET 7 OF 12
SIZE
APPRO V ALS
DR A WN BY
M A TERIAL
FINISH
ADOBE GENER A TED DR A WING
DO NO T MANUAL L Y UPD A TE
CHECKED
RES P ENG
MFG ENG
QUA L ENG
D A TE
DWG. NO.
UNLESS OTHE R WISE SPECIFIED
DIMENSIONS ARE IN INCHES
T OLERANCES ARE :
.XX ± .02
.XXX ± .010
ANGULAR = ± 1°
FINISH = 125 RMS
FRACTIONS = ± 1/64”
SCALE: 1=1 THIS FILE IS IN ADOBE ILLUSTR A T OR
DO NO T SCALE DR A WING
THE INFORM A TION CON T AINED IN THIS DR A WING IS THE SOLE PROPE R T Y OF CYBEX.
AN Y REPRODUCTION IN P A R T OR WHOLE WITHOUT
THE WRITTEN PERMISSION OF CYBEX IS PROHIBITED. . . .
2/7/12
SW-23665-4
LIGHT GREEN PMS 354C (PT-3190)
DARK GREEN PMS 356C (PT-3515)
WHITE (PT-PE01)
YELLOW PMS 142C (PT-2325)
WINDOW DEAD FRONT (PT-3396)
BLACK (PT-PE02)
DARK GRAY PMS 425C (PT-3747)
RED PMS 185C (PT-892)
LIGHT GRAY PMS 424C (PT-2463)
DARK BLUE PMS 2925C
LIGHT BLUE PMS 2905C
RIM /PILLOW EMBOSSED AREAS
EMBOSS
GLOSS AREAS
and DOWN keys for 3 seconds.
4. Press QUICK START.
5. Press the ENTER key three times until “Pivot” is displayed.
6. Stop striding. Wait until foot plates come to a complete stop before dismounting unit. Hold
handrails to steady self while stepping off unit.
7. Press QUICK START to perform calibration. The incline motor will incline to it’s maximum
extension. Stay off footplates until calibration is complete. Incline should be at 20%
(maximum).
8. Press STOP to exit.
9. Hold the handrails to steady self while stepping into the foot plates.
10. Begin striding.
11. Press QUICK START to enter Active Mode.
12. Press incline DOWN and then incline UP to reset inline to 6%.
13. Press STOP to exit. Skip to Install front access cover.
Install front access cover
1. Place front access cover in place.
1
3
2
Description
1 Upper screw (2)
2 Front access cover
3 Lower screw (2)