Cybex 525AT Arc Trainer - Manual (Page 23)

23
Cybex Service Manual
Press the STOP key to return to Dormant Mode. If drive motor was running press the STOP key
again.
Error Codes
Error codes notify user of a problem condition and are displayed on the console. Error codes can also
help to indicate the part of the unit most likely to be causing the problem.
1. Press the STOP key several times.
2. Press the Display option
MEMBRANE, HANDSET,
ARC, BIKE, TREADMILL,
ENGLISH
B A
REVISIONS
DESCRIPTION
See sheet 1
ECO REV D A TE APPRO V AL BY
10 TROTTER DRIVE
MED W A Y , MA
RE V .
SHEET 7 OF 12
SIZE
APPRO V ALS
DR A WN BY
M A TERIAL
FINISH
ADOBE GENER A TED DR A WING
DO NO T MANUAL L Y UPD A TE
CHECKED
RES P ENG
MFG ENG
QUA L ENG
D A TE
DWG. NO.
UNLESS OTHE R WISE SPECIFIED
DIMENSIONS ARE IN INCHES
T OLERANCES ARE :
.XX ± .02
.XXX ± .010
ANGULAR = ± 1°
FINISH = 125 RMS
FRACTIONS = ± 1/64”
SCALE: 1=1 THIS FILE IS IN ADOBE ILLUSTR A T OR
DO NO T SCALE DR A WING
THE INFORM A TION CON T AINED IN THIS DR A WING IS THE SOLE PROPE R T Y OF CYBEX.
AN Y REPRODUCTION IN P A R T OR WHOLE WITHOUT
THE WRITTEN PERMISSION OF CYBEX IS PROHIBITED. . . .
2/7/12
SW-23665-4
LIGHT GREEN PMS 354C (PT-3190)
DARK GREEN PMS 356C (PT-3515)
WHITE (PT-PE01)
YELLOW PMS 142C (PT-2325)
WINDOW DEAD FRONT (PT-3396)
BLACK (PT-PE02)
DARK GRAY PMS 425C (PT-3747)
RED PMS 185C (PT-892)
LIGHT GRAY PMS 424C (PT-2463)
DARK BLUE PMS 2925C
LIGHT BLUE PMS 2905C
RIM /PILLOW EMBOSSED AREAS
EMBOSS
GLOSS AREAS
key, and Speed Down key for three seconds.
3. Press the Up/Down keys until Error Log is displayed. Total number of errors will be displayed.
If three dashes “- - -” are shown, the error log is empty.
4. Press ENTER and use the Up/Down keys to scroll through the error log.
Error Code Listing
Error Code # Meaning
2
GFX Communications issue
4 Upper Display comm. issue
5 Drive comm. issue
6 Membrane fault
8 Approaching Over-Temp
9 MCC Watchdog Triggered
12 Graphics board watchdog
13 Upper display watchdog
14 Drive error unknown
15 Embedded A/V Device failure
16 Membrane fault
18 LCB 12v out of range
19 LCB 3.3v or 50v out of range
29 Controller watchdog tripped
45 AC Incline timeout UP
46 AC Incline timeout DOWN