Cybex 525AT Arc Trainer User Manual

Page 20

Cybex Service Manual

Setup

Use the following instructions to setup the units settings.

1. Plug the power cord into a power outlet from a grounded circuit, See Electrical

Requirements. Coil up the remainder of the power cord and place it out of the way.

2. Toggle the on/off (I/O) power switch under the front end of the unit to the on position (I). The

control panel will light up.

3. Hold the handrails to steady self while stepping into the foot plates.
4. Begin striding.

Time and Date confirmation
The first time the unit is turned on, it prompts the user to confirm the current Time and Date. Quick

Start, Workouts, Setup or Stop will skip this requirement but it will appear again the next time the unit

is powered up until the time and date are properly set.

1. Press the ENTER

key to begin editing the time, starting with the hours (HH) and then

minutes (MM) and then AM/PM/24.

2. Press the UP

and

DOWN

keys to select the hour.

3. Press the ENTER

key to accept and begin editing the minutes.

4. Press the UP

and

DOWN

keys to select the minutes.

5. Press the ENTER

key to accept and begin editing the AM/PM/24 hour setting.

6. Press the ENTER

key to accept time.

Continue this procedure for the Date. Date format is [YYYY] [MM] [DD]. Y - Year, M - Month and D -

Day.

7. Press the ENTER

key after the final setting for Day. The opening screen will now be

displayed.

Time and Date confirmation complete.
Setup options

1. Press and the hold the Display option

and

keys for 3 seconds.

2. Navigate through the setup menu with the UP

and

DOWN

keys.