Cybex 525AT Arc Trainer - Manual (Page 44)

44 45
Cybex Service Manual
Remove incline motor
1. Remove retaining ring from grooved pin using a flat head screwdriver.
3
1
2
Description
1 Retaining ring
2 Groved pin
3 Incline motor
2. Remove grooved pin securing incline motor to main frame.
3. Remove incline motor.
Install new incline motor
1. Place new incline motor in position. Verify center of holes is equal to 10.50” (27 cm).
10.50”
(27cm)
2. Install a retaining ring to one side of grooved pin using a 1/2” ID external retaining-ring tool or
plier.
3
1
2
Description
1 Retaining ring
2 Grooved pin
3 Incline motor
3. Install grooved pin securing the new incline motor to drive frame assembly.
4. Install a retaining ring to other side of grooved pin using a 1/2” ID external retaining-ring tool or
plier.