Cybex 525AT Arc Trainer - Manual (Page 45)

45
Cybex Service Manual
Plug the new incline motor cable into control board.
4
3
6
2
5
1
Description
1 Top screws
2 Incline motor cable
3 Controller cover
4 Bottom screws
5 Control board
6 Cable tie
5. Install wire tie securing the new incline motor cable to frame. Remove excess wire tie with side
cutters.
6. Install controller cover and both lower screws to frame using a Phillips screwdriver.
7. Tighen all four screws securing the contoller cover using a Phillips screwdriver.
Install left shroud
Using a long Phillips screwdriver, install the eight screws securing left shroud in place.
1
2
Description
1 Screws (8)
2 Left shroud
Install lower incline motor support pin.
1. Carefully tilt front end assembly backward until holes in incline motor align with the holes in the
support bracket on main frame.