Cybex 525AT Arc Trainer - Manual (Page 46)

46 47
Cybex Service Manual
2. Attach a retaining ring to one side of grooved pin using a 1/2” ID external retaining-ring tool or
plier.
2
3
1
Description
1 Grooved pin
2 Incline motor
3 Retaining ring
3. Install the grooved pin securing the new incline motor to the main frame assembly.
4. Attach a retaining ring to the other side of grooved pin using a 1/2” ID external retaining-ring
tool or plier.
Install new incline motor cover.
Install the new incline motor cover to main frame with two screws using a Phillips screwdriver.
1
2
Description
1 Incline motor cover
2 Screw (2)
Install linkage rod
1. Install linkage rod on crank arm.
2
3
4
1
5
Description
1 Spacer
2 SHCS
3 Flat washer
4 Cap
5 Linkage rod
2. Place a drop of loctite on the SHCS and place another drop of loctite into the threads of the
shaft.
3. Install SHCS, flat washer, cap and spacer using a Phillips screwdriver. SHCS must be
tightened to a minimum of 90 lbs-in.