Comtech EF Data PCB-4000 - Manual (Page 48)

PCB-4000 1+1 Phase Combiner Revision 2
Updating Firmware MN/PCB4000.IOM
4–10
If the upload is not successful for any
reason (e.g., the comms cable is not
physically connected, the wrong COM
port
is specified, the user
inadvertently interrupted the upload,
etc.), troubleshoot the setup as
needed, and then click on ‘Repeat
Upload’ or ‘Go Back to Start’ to
resume or retry the upload process.
8. Upon successful completion of the upload, you may click
on ‘Go Back to Start’ (if, for example, more than one
PCB‐4000 1+1 Phase Combined System requires
upgrade) or ‘Close’ (to exit the FLSHCAT program).
9. If needed, disconnect the System Programming
Cable (CEFD P/N CA/WR12243‐1) and
reconnect the original System Communications
connection cable.
10. The LEDs on the top of the PCCB may illuminate GREEN
(unmuted), ORANGE (muted), or RED (faulted) to indicate
the current status of the PCCB, SSPA1, and SSPA2 operations.
See
Chapter 3. INSTALLATION, STARTUP, and
TROUBLESHOOTING PROCEDURES for more information on
these operational states.
The PCB‐4000 Firmware Update Process is now complete.