Comtech EF Data RCF6001 - Manual (Page 48)

ODU Installation RCF6001 Satellite Terminal
Page 5-2 TM082 - Rev. 1.0
Unpacking the Outdoor Unit
Each product is completely assembled, tested and then shipped in its appropriate
packaging. Care should be taken when removing equipment from the shipping
container to prevent damage to the units. Ensure that all parts and accessories are
removed from the shipping container and packing material.
Please DO NOT discard the container or any packing material until both a physical and
mechanical inspection of the content has been performed. The container and packing
material must be available if a damage claim is to be made with the carrier.
Step 3. The IDU and ODU are shipped in separate cartons. Remove the ODU from its carton
and verify the contents against the packing slip.
Step 4. The cartons contain the necessary cable connectors, hardware, etc. required to
interconnect the units.
Please adhere to the following procedure when unpacking the shipping container.
Step 3. Remove the tape from the cardboard box flap.
Step 4. Open the box and remove the top foam insert inside the carton.
Step 5. Carefully remove the equipment, manual and accessories.
Step 6. Check for loose components, bent or broken connectors and physical
damage to the outside housing of the equipment.
Step 7. Store the cartons and wrapping material in an appropriate area for future
use.
Step 5. If the shipping container is to be discarded, do not discard the cartons until the contents
has been inspected and all material as been accounted for.
Step 6.
Mechanical Inspection
Inspect the equipment for mechanical shipping damage. Make sure that the equipment
frame is free of damage and that no connectors, controls or indicators are broken,
damaged or loose. Should any damage be discovered after unpacking the system,
immediately file a claim with the carrier. A full report of the damage should be made
and a copy forwarded to Radyne ComStream. Radyne ComStream will then advise
on disposition of the equipment.