Comtech EF Data RCF6001 - Manual (Page 47)

RCF6001 Satellite Terminal ODU Installation
TM082 - Rev. 1.0 Page 5-1
Section 5 – Ku-Band Outdoor Unit Installation Procedures
Introduction
This section provides instruction to integrate and install the 3100 Series Outdoor Unit
(ODU) configured for 1-Watt, 2-Watt, 4-Watt, 8-Watt, 16-Watt or 25-Watts. Within this
text ODU refers to any combination of the following elements: BUC (Block
Upconverter), SSPA (Booster Amplifier) and LNB (Low Noise Block Downconverter).
The combination of the noted elements is based upon the system configuration.
Adhere to the installation sequence listed in Table 5-1.
Table 5-1. Installation Sequence
Procedure Section
Unpacking the System 5.1
Mechanical Inspection 5.1.1
Installation Tools 5.1.2
IFL Cable Installation Guidelines 5.2
General Cable Installation Considerations 5.2.1
Mounting the Typical 1, 2 or 4 Watt Outdoor Unit 5.3
Interface Connections for the 1, 2 or 4 Watt Outdoor Unit 5.4
Mounting the Typical 8 or 16 Watt Outdoor Unit 5.5
Interface Connections for the 8 or 16 Watt Outdoor Unit 5.6
Installation Verification 5.7