Comtech EF Data CDM-625A - Manual (Page 78)

CDM-625A Advanced Satellite Modem MN-CDM625A
Introduction Revision 3
1–34
1.4.9 Miscellaneous
Front Panel Tactile keypad, 6 keys (up, down, left, right, ENTER, CLEAR)
Vacuum Fluorescent Display (blue) – two lines @ 40 characters/line
Loopbacks Internal IF loopback, RF loopback, digital loopback, and inward/outward loopback
Fault relays Hardware fault, Rx and Tx Traffic Alarms, Open Network Backward Alarms
Type: Form C Contacts. Rating: Up to ±50 volts, maximum 0.5 Amp
M&C Interface EIA-232 and EIA-485 (addressable multidrop, 2-wire or 4-wire) or Ethernet (10/100 BaseT)
M&C Software Serial comms, SNMP, Telnet, HTTP (Web Server)
Firmware update FTP protocol via Ethernet port
Dimensions 1RU high, 17.65 inches (448 mm) deep
Weight 10.5 lbs (4.8 kg) maximum (All option cards and 48V BUC supply installed)
AC consumption 48 watts (typical, TPC/LDPC Codec module installed), 68 watts (maximum)
280 watts (typical, TPC/LDPC Codec module and 48 volt BUC supply installed, 300 watts (max)
AC operating voltage 100-240 VAC Nominal - autosensing
90-264 VAC Maximum
DC consumption (option) As above (AC consumption)
DC operating voltage 20-60 VDC Nominal
36-60 VDC Maximum
Operating temperature 32°-122°F (0°-50°C)
‘ER’ VERSION: 32°-140°F (0°-60°C)
1.4.10 Approvals
“CE” as follows:
EN 55022 Class B (Emissions)
EN 50082-1 (Immunity)
EN 60950-1 (Safety)
EN 61000-3-2
EN 61000-3-3
EN 61000-4-2
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 61000-4-8
EN 61000-4-9
EN 61000-4-11
EN 61000-4-13
FCC Federal Communications Commission Federal Code of Regulation FCC Part 15, Subpart B.