Comtech EF Data CDM-625A - Manual (Page 183)

CDM-625A Advanced Satellite Modem MN-CDM625A
Front Panel Operation Revision 3
6–57
CONFIG: IP  SNMP  Traps
Traps: Community Version
IP-Addr#1 IP-Addr#2 ()
Use the ◄ ► arrow keys to select a parameter. Press ENTER.
CONFIG: IP  SNMP  Traps  Community
SNMP Traps Community:
Comtech (20 chars) ()
Edit the SNMP Traps Community string by using the ◄ ► arrow keys to select a character. Then,
use the ▲▼ arrow keys to change that character, and press ENTER.
Only the first 20 characters on the bottom line are available.
All printable ASCII characters are available with the exception of the backslash (ASCII code 92)
and tilde ~ (ASCII code 126). Press ENTER after composing the string. All trailing spaces are
removed from the string upon entry.
CONFIG: IP  SNMP  Traps  Version
SNMP Traps Version:
SNMP-ver1 (ver1,ver2) ()
Use the ◄ ► arrow keys to select SNMP-ver1 or SNMP-ver2. Press ENTER.
CONFIG: IP  SNMP  Traps  Address
Trap IP addr #1:
000.000.000.000 ()
Edit the SNMP Trap Destination’s IP Address by using the ◄ ► arrow keys to select a digit. Then,
use the ▲▼ arrow keys to change that digit, and press ENTER.
You may disable SNMP Traps by setting both Trap IP Addresses as 000.000.000.000.