Comtech EF Data CDM-625A - Manual (Page 375)

CDM-625A Advanced Satellite Modem MN-CDM625A
Serial-based Remote Product Management Revision 3
8–63
Parameter
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to Query
QoS Mode QOS= 2 bytes, each 0
thru 3
Command or Query.
Sets or returns QoS (Quality of Service) Mode in the form ab, where:
a=Layer 2 QoS:
0=Off, Layer 2 QoS is disabled
1=VLAN Priority only
2=Port Priority only
3=VLAN and Port Priority
b =Layer 3 QoS:
0=Off, Layer 3 QoS is disabled
1=Advanced QoS Max / Priority (requires Advanced QoS FAST Option)*
2=Advanced QoS Min Max (requires Advanced QoS FAST Option)*
3=Advanced QoS DiffServ (requires Advanced QoS FAST Option)*
*Note: Layer 3 QoS settings 1 through 3 apply to modem only with IP Packet Processor option card installed and enabled.
QOS=
QOS?
QOS*
QOS#
QOS? QOS=ab
(see Description of
Arguments)
Switch Ports
Configuration
SPC= 47 bytes Command or Query.
Sets or returns Ethernet switch ports’ priority and PVID in the form 1abccccdxxx;2abccccdxxx;3abccccdxxx;4abccccdxxx,
where:
1, 2, 3, or 4=Port number.
a=Port priority: Value=1, 2, 3 or 4 (the higher the number, the higher the priority).
b=Port Native Mode: 0=Native Mode Disabled, 1=Native Mode Enabled.
cccc=Port VLAN ID: Value range=0000-4095 – Value 0000 is only valid when port Native Mode is disabled.
d=Pause flow control. 0=Off, 1=On
xxx=Reserved.
SPC=
SPC?
SPC*
SPC#
SPC? SPC=1abccccdxxx,2ab
ccccdxxx,3abccccdxxx,
4abccccdxxx
(see Description of
Arguments)
Edit entry in
VLAN table
SVE= 8 bytes Command only.
Edit VLAN table entry in the form aaaabcde, where:
aaaa=existing VLAN ID – Value range is 0001-4095.
b=property of port 1: 0=Tagged, 1=Filtered, 2=Untagged
c=property of port 2: 0=Tagged, 1=Filtered, 2=Untagged
d=property of port 3: 0=Tagged, 1=Filtered, 2=Untagged
e=property of port 4: 0=Tagged, 1=Filtered, 2=Untagged
SVE=
SVE?
SVE*
SVE#
N/A SVE=aaaabcde
(see Description of
Arguments)
Packet
Processor
Working Mode
WMD= 1 byte, 0 thru 3 Command or Query.
Sets or returns Packet Processor Working Mode in the form x, where:
0=Managed Switch
1=Router Point to Point*
2=Router Multipoint Hub*
3=Router Multipoint Remote*
*Note: Settings 1 through 3 apply to modem only with IP Packet Processor option card installed and enabled.
WMD=
WMD?
WMD*
WMD#
WMD? WMD=x
(see Description of
Arguments)