Comtech EF Data CDM-625A - Manual (Page 501)

CDM-625A Advanced Satellite Modem MN-CDM625A
CDM-625A ODU (Transceiver, BUC, LNB) Operation Revision 3
10–33
Mute=Disabled Att-Offset=00.00dB
This screen displays the RF Amplifier state, RF Mute state, Attenuation, and AUX Mute state.
ODU: FSK-control BUC  Advanced-FSK  LPOD (2LPODs 
Online/Offline LPOD) Information  LNB
LNB Current: Src=On SwitchBiasTee=Off
Window:30% Alarm=Disabled
This screen displays the LNB Current information.
ODU: FSK-control  BUC  Advanced-FSK  LPOD (2LPODs 
Online/Offline LPOD) Information  Mask
Mask: LFRFPwr=Masked ERLD=Masked
FanSpd=Alarm LNBCD=Alarm LNB22V=Alarm
This screen displays the LPOD mask settings.
ODU: FSK-control  BUC  Advanced-FSK  LPOD (2LPODs 
Online/Offline LPOD)  Information  Misc
Misc: AFR=Enabled Ref-Adjust=087
LowFwdPowerThreshold=00.00
This screen displays the Auto Fault Recovery state, the Internal 10MHz Reference setting, and
the Low Forward Power Threshold setting.
10.3.3.3.3.4.3.1.6 ODU: FSK-control  BUC  Advanced-FSK  LPOD
(2LPODs Online/Offline LPOD)  Redun
Redundancy-Switch-Mode=1:1 Red TX+RX
Force-Online=N Online-State=Offline()
Use the ◄ ► arrow keys to select a setting, and then use the ▲▼ arrow keys to change that
setting:
Selection Setting
Redundancy-Switch-Mode Off, 1:1 Red Tx, 1:1 Red TX+RX, Manual.
Force-Online
Select Yes to force Offline unit to generate a redundant switchover.
Otherwise, select No.
Online-State Read-only. Displays status as Online or Offline.
Press ENTER when done.