Comtech EF Data CDM-800 - Manual (Page 78)

CDM-800 Gateway Router Revision 1
Ethernet-based Remote Product Management MN-CDM800
5–18
5.4.4.3 Configuration Pages
Use the nested ‘Configuration’ pages to configure all unit parameters. Click the Interface, Mod,
ARP, Routing, Compression, or WAN tab to continue.
5.4.4.3.1 Configuration | Interface
Click the FE Mgt, GE‐1, or GE‐2 tab to continue.
5.4.4.3.1.1 Configuration | Interface | FE Mgt
Use this page to configure the rear panel ‘FE’ 10/100 BaseT Fast Ethernet M&C port.
Figure 5‐9. Configuration | Interface | FE Mgt Page
FE – Management Interface
The acceptable/valid operating ranges for items in this section are provided in parentheses.
• MAC Address (read‐only) – The MAC Address cannot be changed.
• IP Address / CIDR Mask (8‐30) – Use this box to enter the IP Address and CIDR (Classless
Inter‐Domain Routing) Subnet Mask.
• Link Configuration – Use the drop‐down menu to select the line speed and duplex setting
for the CDM‐800 FE interface. The available selections are:
o Auto* o 100 BaseT / Full Duplex o 10 BaseT / Full Duplex
o 100 BaseT / Half Duplex o 10 BaseT / Half Duplex