Comtech EF Data CDM-800 - Manual (Page 26)

CDM-800 Gateway Router Revision 1
Introduction MN-CDM800
1–6
1.3.3.2 Rear Panel
PROPER GROUNDING PROTECTION IS REQUIRED. The equipment must be connected
to the protective earth connection at all times. It is therefore imperative that the unit
is properly grounded, using the ground stud provided on the unit rear panel, during
installation, configuration, and operation.
• Sect. 3.2 CDM‐800 Cabling Connections
• Sect. 3.3 CDM‐800 Grounding and Power Connections
External cables are attached to connectors provided on the rear panel of the unit (Figure 1‐5).
Figure 1-5. CDM-800 – Rear Panel View
1.3.3.2.1 Rear Panel Standard Features
The unit provides the following standard interfaces:
Data Interfaces:
• (2X) 10/100/1000 BaseT Gigabit Ethernet RJ‐45 Interfaces (GE1, GE2 ports) for Ethernet
traffic.
• (1X) 10/100 BaseT Fast Ethernet RJ‐45 Interface (FE port) for HTTP and SNMP
management and control purposes (Web and SNMP).
• (1X) DB‐9F EIA‐232 connector for serial remote control (CONSOLE port).
Tx (Transmit) IF Interfaces
• (1X) Type ‘N’ female connector for 50Ω L‐Band (950 to 2150 MHz)
• (1X) Type ‘BNC’ female connector for 62Ω 70/140 MHz
Power Interface
• 115/230 VAC Primary Input Power Supply with Press‐fit Fuse Holder
(Top) Standard AC Unit
(Bottom) Optional 48V DC Unit