Comtech EF Data CDM-800 - Manual (Page 62)

CDM-800 Gateway Router Revision 1
Ethernet-based Remote Product Management MN-CDM800
5–2
5.2 Ethernet Management Interface Protocols
The user PC facilitates access to Ethernet‐based remote monitor and control (M&C) of the
CDM‐800 through two separately‐operated protocols:
• Simple Network Management Protocol (SNMP). This requires a user‐supplied Network
Management System (NMS) and a user‐supplied Management Information Base (MIB) File
Browser.
• The CDM‐800 Web Server (HTTP) Interface. This requires a compatible user‐supplied Web
browser such as Internet Explorer.
5.2.1 Ethernet Management Interface Access
Access to the CDM‐800 Ethernet Management Interface requires the user to specify the unit
Management IP Address. Via use of a terminal emulator connected to the rear panel 9‐pin serial
‘CONSOLE’ port, this address may be obtained from the CDM‐800 Serial Interface upon power‐
up of the unit. As shown, a number of operational parameters (including the unit factory‐default
IP addresses) are displayed.
The factory‐assigned default IP addresses are provided in the table that follows (if otherwise
assigned, the user may use the last column to write down the IP Addresses for future reference):
Description Default Address User-assigned Address
‘FE’ Management IP Address 192.168.1.10 _____________________
‘GE1’ (GigE Traffic ) IP Address 10.10.1.10 _____________________
‘GE2’ (GigE Traffic ) IP Address 10.10.2.10 _____________________
See Chapter 6. SERIAL‐BASED REMOTE PRODUCT MANAGEMENT for details on
setting up and using the CDM‐800 Serial Interface.