Comtech EF Data CDM-800 - Manual (Page 118)

CDM-800 Gateway Router Revision 1
Serial-based Remote Product Management MN-CDM800
6–10
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to Query
GE2 Address IG2= 18 bytes numerical Command or Query.
Sets the IP Address and network prefix for the 10/100/1000 BaseT GE2 Ethernet
port, in the form aaa.bbb.ccc.ddd/yy, where:
(Permitted ranges – cannot all be zero)
aaa = 0-223
bbb = 0-255
ccc = 0-255
ddd = 0-255
yy = network prefix (range: 8 to 31)
Other restrictions:
If aaa>191, prefix may not be less than 24.
If aaa>127, prefix may not be less than 16.
Example: IG2=010.006.030.001/24
IG2=
IG2?
IG2*
IG2#
IG2? IG2=xxx.xxx.xxx.xxx/yy
(see Description of Arguments)
Management IP
Address IPA= 18 bytes numerical Command or Query.
Sets the IP Address and network prefix for the 10/100 Base T Ethernet
management port, in the form aaa.bbb.ccc.ddd/yy, where:
(Permitted ranges – cannot all be zero)
aaa = 0-223
bbb = 0-255
ccc = 0-255
ddd = 0-255
yy = network prefix (range: 8 to 31)
Example: IPA=010.006.030.001/24
IPA=
IPA?
IPA*
IPA#
IPA? IPA=xxx.xxx.xxx.xxx/yy
(see Description of Arguments)
GE1 Link
Configuration LC1= 1 byte, value 0 thru
5 Command or Query.
GE1 Interface mode, where:
0 = Auto Negotiate
1 = 1000Mbps -Full Duplex
2 = 100Mbps – Full Duplex
3 = 100Mbps – Half Duplex
4 = 10Mbps – Full Duplex
5 = 10Mbps – Half Duplex
LC1=
LC1?
LC1*
LC1#
LC1? LC1=x
(see Description of Arguments)
GE2 Link
Configuration
LC2= 1 byte, value 0 thru
5
Command or Query.
GE2 Interface mode, where:
0 = Auto Negotiate
1 = 1000Mbps -Full Duplex
2 = 100Mbps – Full Duplex
3 = 100Mbps – Half Duplex
4 = 10Mbps – Full Duplex
5 = 10Mbps – Half Duplex
LC2=
LC2?
LC2*
LC2#
LC2? LC2=x
(see Description of Arguments)