Comtech EF Data CDM-800 - Manual (Page 53)

CDM-800 Gateway Router Revision 1
Updating Firmware MN-CDM800
4–3
See Chapter 6. SERIAL‐BASED REMOTE PRODUCT MANAGEMENT for
information and instructions on using the CDM‐800 Serial Command Line
Interface.
E. Alternately, use the CDM‐800 Web Server Interface to obtain the firmware information.
• Use an Ethernet hub, switch, or direct
cable connection to connect the
CDM‐800 ‘FE’ 10/100 Fast Ethernet
port to the PC.
• On the PC: Use a Web browser (e.g., Internet Explorer) to log in to the CDM‐800
Web Server Interface and access the ‘Admin | Firmware’ page. Then, make note of
the Slot #1 and Slot #2 firmware loads:
See Chapter 5. ETHERNET‐BASED REMOTE PRODUCT MANAGEMENT for
information and instructions on using the CDM‐800 Web Server
Interface.
2. Next, create a temporary folder (subdirectory) on the user PC for the firmware archive
download.
• Drive letter “c:” is used in these examples. Any valid, writable drive letter
can be used.
• Typical for all tasks: Type the command without quotes, and then press
Enter to execute.