Comtech EF Data CDM-800 - Manual (Page 116)

CDM-800 Gateway Router Revision 1
Serial-based Remote Product Management MN-CDM800
6–8
6.3 Remote Commands and Queries
The Serial Command Line interface (CLI) (the Controller), shown previously in Figure 5‐1, is used to issue remote commands and queries
to the CDM‐800 (the Target). From the CLI command prompt CDM‐800> type in the command or query packet, using the format
explained previously, for transmission to the CDM‐800.
For example: CDM‐800><0000/LC1=3[cr]
The table that follows provides a ‘quick reference‘ to the Instruction Codes available at present for M&C of the CDM‐800. The ‘C’ and ‘Q’
columns, when marked with an ‘X’, denote whether that Instruction Code is Command Only, Query Only, or Command and Query.
INSTRUCTION
CODE
USED TO... C Q Page
DPW Set default passwords X 5‐9
IG1 Set or query the IP Address and network prefix for the GE‐1 10/100/1000 Gigabit Ethernet Port X X 5‐9
IG2 Set or query the IP Address and network prefix for the GE‐2 10/100/1000 Gigabit Ethernet Port X X 5‐10
IPA Set or query the IP Address and network prefix for the FE (10/100 Fast Ethernet) port X X 5‐10
LC1 Set or query the link configuration for the GE‐1 10/100/1000 Gigabit Ethernet Port X X 5‐10
LC2 Set or query the link configuration for the GE‐2 10/100/1000 Gigabit Ethernet Port X X 5‐10
MAC Query the unique router MAC Address X 5‐11
MG1 Query the unique GE‐1 port MAC Address X 5‐11
MG2 Query the unique GE‐2 port MAC Address X 5‐11
MLC Set or query the link configuration for the FE Port X X 5‐11
NPS Query the negotiated port speeds for the GE‐1, GE‐2, and FE ports X 5‐11
SRC Set or query the SNMP Read Community String X X 5‐11
SWC Set or Query the SNMP Write Community String X X 5‐11