Beisler 1265-5 - Manual (Page 52)

6.11 Program m ing m enus
6.11.1 G eneralnotes
The program m ing m enus allow the generation ofprogram s and the
corresponding seam s.
In principalitis possible to generate a com plete new program .A n
easierw ay is:
l to copy a program provided by the m anufacturerto a free storage
location in the m em ory and to adaptitto the conditions ofyour
production.
l to copy an already m odified program to a free storage location in the
m em ory and to furtheradaptit.
In orderto generate a new program the follow ing steps are required:
1) A llocate a free storage location
2) A dd seam s orcopy existing seam s
to a program
3) C onfigurate seam s (adaptthem to the production)
S crolling dow n the program m ing levels
W hen the program m ing m enus are called up,the m enu dealtw ith last
is alw ays indicated.
The num berpreceding the functions show s w hich program m ing level
has been called up.
In orderto callup a certain function you have to scrolldow n the
program m ing m enus and service m enus.
C alling up a program m ing m enu
– P ress key “P ”.
S crolling dow n a program m ing m enu
– P ress key “
ï“.
6.11.2 A llocating a free storage location
The storage locations M 01 -M 10 have been provided w ith program s by
the m anufacturer.The storage locations M 11 -M 20 are free.
– P ress key “M ”.
– E nterthe tw o-digitnum bervia the num eric pad.
6.11.3 F1 = IN IT Param eter
Functions in the m enu InitP aram eter:
l F1 = EPR O M globalparam eter
l F2 = EPR O M seam param eter
l F3 = copy seam num ber
l F4 = delete seam
1
49