Beisler 1265-5 - Manual (Page 110)

3.4.3 C hanging the toothed beltofthe ejector
C aution:R isk ofinjury!
S w itch the m ain sw itch off.
C hange the toothed beltonly w ith the sew ing unitsw itched off.
– Low erthe feeding unitonto the table top m anually.
– S w itch the sew ing unitoff.
– S crew the screw 3 outofthe cylinder2.
– Loosen screw 4 and release the tension ofthe toothed belt5.
– R em ove the toothed beltfirstfrom the drive rolland then from the
feed roller6 ofthe ejector.
– Fitthe new toothed beltin reverse order.
– Tension toothed belt5 and tighten screw 4.
Ifthe tension is correct,itm ustbe possible to bend the toothed
belt5 in the m iddle by approx.10 m m w ith sensible counter
pressure.
– S w ivelthe cylinder2 to the frontagain and screw iton the ejector
w ith screw 3.
35
3
3 2 1 6 5 4