Avery Dennison 676 - Manual (Page 44)

44 • •• • Adjustments
Stock Width Adjustment
Loosen the two thumbscrews behind the stacker uprights and adjust the stacker
upright nearest to the operator to the desired stock width position. Re tighten.
Stacker Angle Adjustment
Loosen the lever located on the side of the stacker assemble nearest the operator and
adjust the angle of the stacker with a few cut labels in the stacker so that there is a
slight gap under the last label as it hangs over the last belt drive roller. Re tighten.
Stacker Full Adjustment
The switch on the inboard stacker up right is used to stop the printer when the stack
is full. A thumbscrew adjustment is provided to set the stack height.
Warning: Some stock materials cannot be stacked to the full height of the
stacker because of excessive weight.