Analog Way VERTIGE - Ref. VRC300 User Manual - Manual (Page 6)

6
2.1.1 English
2. HARDWARE INSTALLATION
All of the safety and operating instructions should be read before the product is operated and should
be maintained for further reference. Please follow all of the warnings on this product and its operating
instructions.
• WARNING: To prevent the risk of electric shock and fire, do not expose this device to rain, humidity or
intense heat sources (such as heaters and direct sunlight). Slots and openings in the device are provided for
ventilation and to avoid overheating. Make sure the device is never placed near a textile surface that could
block the openings. Also keep away from excessive dust, vibrations and shocks.
• POWER: Only use the power supply indicated on the device of the power source. Devices equipped with
a grounding plug should only be used with a grounding type outlet. In no way should this grounding be
modified, avoided or suppressed. Connection of equipment to main supply must be after branch circuit
breaker of the building installation.
• POWER CORD: The device is equipped with 2 detachable power cords, to remove mains, disconnect them
at appliance coupler.
Caution: The power cords constitute the only mean to completely disconnect the equipment from the main
power. To make sure the device is not supplied, these two cords must be unplugged from the mains
outlet.
Use the following guidelines:
- The equipment connected to the network must have a release system easily accessible and located
outside the unit.
- Unplug both power cords; do not pull on the power cords but always on the plug itself.
- The outlets should always be near the device and easily accessible.
- Power supply cords should be routed so that they are not likely to be walked on or pinched by items
placed on or against them.
If one of the power supply cords is damaged, unplug the device. Using the device with a damaged power
supply cord may expose your device to electric shocks or other hazards. Verify the condition of the power
supply cords periodically. Contact your dealer or service center for replacement if damaged.
• CONNECTIONS: All inputs and outputs (except for the power input) are Safety Extra Low Voltage (SELV)
circuits as defined in UL/IEC 60950-1.
• SERVICING: Do not attempt to service this product yourself by opening or removing covers and screws
since it may expose your device to electric shocks or other hazards. Refer all problems to qualified service
personnel.
• OPENINGS: Never push objects of any kind into this product through the openings. If liquids have been
spilled or objects have fallen into the device, unplug it immediately and have it checked by a qualified
technician.
2.1 Safety instructions
2.1.1 English