Analog Way VERTIGE - Ref. VRC300 User Manual - Manual (Page 15)

15
4.1.1 System configuration
4. STARTING WITH THE VERTIGE™
4.1.1 System configuration
4.1 Operational configuration
When the Vertige™ starts up, the Home page is automatically displayed. Press the START button, then
press the Vertige™ SETTINGS button in the upper-right corner.
The Vertige™ Settings page allows you to configure the IP address of the Vertige™ and update it via a USB
port:
• Configuring the network:
In the top bar, select the Network Editor
tab. Select the Ethernet port used by the
Vertige™ on your network then enter
the corresponding IP address, subnet
mask and gateway. When ready, press
the Apply button.
• Updating the firmware:
In the top bar, select the Firmware
Updater tab. The upper area displays the
current firmware version. Make sure the
USB flash drive you are using contains
an up-to-date version of the Vertige™
firmware. Plug this USB flash drive into
one of the Vertige™ USB connectors.
Wait for the device to appear in the
Storage list then select it to display the
firmware updaters available. Select the
desired update from the list then press
the Update button to start updating the
Vertige™.
IMPORTANT: Do not remove the USB flash drive or turn off the power while updating.