5 iteration wizard – Analog Way VERTIGE - Ref. VRC300 User Manual User Manual

Page 18

4.1.5 Iteration Wizard

• Loading an iteration:

In the left menu, select the

LOAD

option.

Select the iteration you want to load and

then press the

Load

button to load this

iteration and begin working on your

event setup.

• Exporting an iteration to a USB key:

In the left menu, select

TRANSFER

then

select the

EXPORT

option. Select the

iteration you want to export then plug a

USB flash drive into one of the Vertige™

USB connectors. Wait for the device to

appear in the

Storage

list, then select it and press the

Export

button to start exporting this iteration.

• Importing an iteration from a USB key:

In the left menu, select

TRANSFER

then select the

IMPORT

option. Plug a USB flash drive into one of the

Vertige™ USB connectors. Wait for the device to appear in the

Storage

list, then select it to display the

iterations available. Select the iteration you want to import then press the

Import

button to start importing

it into the current show (as a new iteration index).

4.1.5 Iteration Wizard

The

Iteration Wizard

page is the first step

you should go through once you have

loaded an empty iteration. It allows you

to setup one device in just a few quick

steps:

Wizard Step 1:

In the

Device Type

field, select the type

of device you want to control.

Select the

Single or Synchronized

option

if you have a single device or if your

devices will synchronized for achieving

bigger screens (associative modularity).

When synchronized, all the sources must

be shared and configured the same way

on all devices.

Select the

Linked with SLAVE

option, if

the device is linked to another compliant

device (additive modularity).

Select the

Linked with LOE

option, if the

device is linked to a LiveCore Output

Expander (additive modularity).

If your devices have the 4K option, make

sure to check the

box.

Select a quantity of devices then adjust

each device IP address to match your

network configuration. Press the

Next

button to continue.