Analog Way VERTIGE - Ref. VRC300 User Manual - Manual (Page 21)

21
4.1.6 Assembly configuration
• Configuring the device(s) monitoring
outputs:
In the left menu, select the CONFIGURE
/ MONITORING option then select the
assembly for which you want to configure
the monitoring outputs: Select one of
the physical monitoring outputs in the
list then adjust the settings accordingly
(Rate, Format, HDCP protection, Gamma,
signal type…).
• Configuring the device(s) inputs:
In the left menu, select the CONFIGURE
/ INPUT option then select the assembly
for which you want to configure the
inputs: To automatically configure all the
inputs, simply press the All inputs button
located in the AUTO SET panel. Or press
the Input #x button to automatically
configure the selected input only.
If the input signal type has not been
detected or set up properly, you can
adjust it manually below.
• Configuring the standard streams:
In the left menu, select the STREAMS
/ STANDARD option then select the
assembly for which you want to
configure the standard streams: To add
a new stream, enter the name of this
stream then select the stream type (Live,
Frame or Logo). For a Live stream, select
the desired input and plug. For a Frame
or a Logo stream, simply select one of
the frames or logos available in the list.
When ready, press the Add button. To
edit existing standard stream properties,
select a stream in the list and adjust the
desired properties.
When done, press the Apply button to save your changes. To delete a standard stream, simply select the
corresponding item in the list and press the Remove button.
• Configuring the native streams:
In the left menu, select the STREAMS / NATIVE option then select the assembly for which you want to
configure the native streams: To add a new native stream, first enter the name of this stream then, if this
native stream will be used for filling the background of a blend, adjust its size accordingly. For each screen
area defined, select the desired standard stream that will be displayed in this area.