Analog Way VERTIGE - Ref. VRC300 User Manual - Manual (Page 35)

35
Presets can be saved, loaded and renamed directly from the Preset page on the touchscreen.
For more information please read chapter 4.1.14 Presets management.
5.3.2 How to load a preset
5.3.1 How to save a preset
To save a preset, first create the content that you wish to save on either the Program or Preview screens. To
save a preset from Program, make sure that the Program button is selected. To save a preset from Preview,
make sure that the Preview button is selected. To save a preset, press the SAVE button next to the preset
bank and page navigation buttons. Then navigate to the preset slot that you wish to save to, and press once
on the desired preset button. The preset will turn yellow, indicating a successful save.
Preset slots that already contain a saved preset will be indicated in yellow. Empty preset slots will be indicated
in green. If you attempt to save over an existing preset, you will have to confirm the operation by pressing on
the blinking preset button a second time.
If you would like to exclude some screens from the preset
memory, you will need first to ‘deactivate’ them before
saving the preset. Please read chapter 5.6 Transition section
to understand how to activate/deactivate a screen.
The Save function will remain active until you manually switch
back to load mode, so it is recommended to switch back to
Load mode as soon as you are finished saving presets.
5.3.2 How to load a preset
First be sure that the Preview button is selected if you wish to load the preset to Preview, or that the Program
button is selected if you wish to load the preset to Program.
To Load a preset, make sure that the LOAD button next to the preset bank and page navigation buttons has
been selected. If it has already been selected, you do not need to press it again. Next, select the desired
preset that you wish to load. The preset will be loaded to Program or Preview, depending on which button
has been selected. Note that loading a preset will change the content of the relevant screens only, i.e. those
that were active when the preset has been saved; other screens will be automatically ‘deactivated’ but their
content will not change.
If you have loaded your preset to Preview, you will need to press TAKE to view it on the Program screens.
If you load a preset directly to Program, the new attributes including sources, size, position, border, etc will
cut into place.
5.3 Preset section