Analog Way LIVECORE OUTPUT EXPANDER 16 - Ref. LOE016 - Manual

LiveCore™ Output Expander
- Ref. LOE016
QUICK START GUIDE
Thank you for choosing Analog Way and the LiveCore™ Output Expander. By following these simple steps,
you will be able to set up and use your Powerful multi-screen Seamless Switcher based on Analog Way ’s new
LiveCore™ platform within minutes. Discover the LiveCore™ Output Expander capabilities and intuitive interface
while commanding top-notch presentations and unleash your creativity for a new experience in show and event
management.
• 1 x LiveCore™ Output Expander (LOE016)
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device control)
• 1 x MCO 10 pin connector
• 1 x Web-based Remote Control Software included and hosted on the device
• 1 x Rear rack mount kit (the parts are stowed in the packaging foam)
• 1 x Quick start guide*
• 1 x Safety instructions datasheet
• 3 x LiveCore™ Link cable (OPT-LINK)
* The Quick start guide is also available on
www.analogway.com
WHAT’S IN THE BOX
QUICK INSTALL AND SETUP
Connecting with the Web RCS
The LiveCore™ Output Expander uses standard
ethernet LAN networking. To connect the LiveCore™
Output Expander, you first need to connect it to
the same network than your SmartMatriX Ultra or
Ascender 16 and your computer. To be sure it is on the
same network than your computer, open an internet
browser which supports Flash® player.
Into this internet browser, please enter the IP address
of the LiveCore™ Output Expander displayed on the
front panel screen.
The connection should start.
Often, computers are set to DHCP client (automatic
IP detection) mode. You may need to change the
IP address configuration on your computer before
you can connect. These settings are found in the
properties for your LAN network adaptor, and vary by
operating system.
The default IP address on the LiveCore™ Output
Expander is 192.168.2.140 with a netmask of
255.255.255.0. Therefore, you can assign your
computer a static IP address of 192.168.2.100 and
a netmask of 255.255.255.0 and should be able to
connect.
If the connection is not starting, please see:
• Be sure the computer IP address is on the same
network and subnet as the LiveCore™ Output
Expander.
• Be sure that no two devices have the same IP
address (prevent IP conflicts)
• Check your network cable. You will need a crossover
ethernet cable if you are connecting directly from
the LiveCore™ Output Expander to the computer.
If a hub or switch is involved, use straight ethernet
cables.
• For more information, please see the user manual
or contact your local technical support.
Once you have successfully connected, the flash
app will automatically download and launch in your
browser. When the two icons in the bottom right
corner of the screen turn green, the Web RCS is ready
to use. If you are having trouble syncronizing, try
clearing the cache and refreshing the page (ctrl+F5 in
most browsers):
- LOE016: will turn green when connected
- Synch OK: will turn green when the Web RCS has
finished syncronizing.
CAUTION!
Mounting using only the front
rack ears is sufficient for fixed
installations. Additional support,
such as the rear rack support or
slide rails, is required for mobile
applications, and recommended
for all.