Analog Way VERTIGE - Ref. VRC300 User Manual - Manual (Page 39)

39
5.7.2 Controlling the cue sequence playback
5.7 Control transition section
Into the control transition section, you can choose either to control the transition (default section behavior)
or to control the cue sequence playback.
5.7.1 Controlling the transition
• FILTER SELECT button:
The FILTER SELECT button allows you to quickly edit the transition filter based on current layer selection.
• TOGGLE button:
Enabling the TOGGLE button turns your device into the toggle preset mode. That means that after a take,
your old Program becomes your new Preview.
• STEP BACK button:
The STEP BACK button allows you to restore on Preview the configuration of the Program before the last
transition.
• TAKE CUT button:
Pressing the TAKE CUT button, you will take your Preview to Program but without all the programmed effects.
They will be all replaced by the cut effect.
• TRANSITION DURATION button:
You can enable or not this button by pressing on it. The yellow color means this function is enabled. When
enabled, this duration overrides all the specific screens durations.
• TAKE button:
The TAKE button allows you to send your selected Preview screens to Program.
5.7.2 Controlling the cue sequence playback
To control the cue sequence playback from the front panel, simply press the CUE SEQUENCE key to enable
the cue Sequence playback control mode (key illuminated). To return to the Transition Control mode, press
the CUE SEQUENCE key again (key backlight turned off).
• PLAY button:
Pressing the PLAY button starts the cue sequence
continuous playback from the selected cue.
The status bar displays the player status.
Cue Sequence playback control mode is automatically enabled when user starts playback by
pressing the PLAY button on the touchscreen.